On Dec 20, 9:49 pm, "Jimi" wrote:
I am sheeting in a raised platform about 4 ft off the ground with
tongue and groove cedar...I then am sheeting in a wall from the floor up to
this platform also using the same material.....question is how or what kind
of finish do I use where the wall meets the platform? Gonna look like
this:

________________________________________ ----- what do I do with this
outside corner to finish it nice?

|

|

|

|

|

|

|

|

A website with some photos would be wonderful!....Googled it but am not sure
what to ask for... Thanks in advance...Jim

Well I'm not exactly sure what you are asking here. To really do a
nice job, you should have a chop saw that bevels to 45 degrees and you
should have a table saw. Hard to get professional results without
those tools. Outside corners look best mitered. The alternative is
some kind of corner cap trim which you would probably have to make.
For inside corners, it looks best butted tight with no trim. However,
a lot of people find it necessary to add some sort of molding.