1/2 inch silicone bead too big?
On 11 Dec, 22:14, wrote:
On Tue, 11 Dec 2007 05:41:23 -0800 (PST), "
wrote:
I've recently tiled my bathroom and left a 1/2 inch gap between the
tiles and the bath. This seems a bit wide to seal with a bead of
silicon. The install notes that came with the bath recommend a 1/4
inch gap max.. And filling the bath with water will increase the gap
even more.
What are the best options for sealing tround the bath?
* Cut a big bead width on the tube and go for it.
* Apply the silicone in several layers, over a few days.
* Use some sort of sealing strip.
* Pack or fill the cavity (what with?) to reduce the gap.
Advice welcomed.
Thanks
Mike
a practised mastic applier can do a 12 mm joint no problem
you may need to practice
apparently you can buy a tool that gives a good finish on the web
i woul;d roll a sheet of newspaper into a tube the right size and push
that into the gap
you may need more than 1 tube
and you should clean every thing including your hands before you start
1/2in gap big deal
breeze
Sounds like it's worth a try. Rather than use paper to fill the void,
I was thinking of using draught-proofing strip or similar. Then
silicone over the top.
Using a quadrant bead tile is also worth investigating.
Thanks
Mike
I
|