Just keep an eye on that fixture. If it goes out prematurely, replace the
socket





"-hh" wrote in message
...
Thanks for the comments, all.

"RBM" rbm2(remove wrote:
The problem with all MR-16 fixtures, is the intense heat at the bi-pin
ceramic socket. Once the socket overheats, it anneals the metal in the
socket causing a poor connection,which causes to heat more, and
eventually
self destruct. Often you can install a new lamp and it will work for a
short
while, then the pins will burn and it to will go out.


So it sounds like that the additional insert/remove from my
troubleshooting exposed enough fresh metal to make a good contact.

The remedy is to
replace the socket. Some manufacturers like Lightolier have quick
disconnects on their sockets, knowing that they'll need to be replaced,
others will require a high temperature splicing device

Will keep it in mind. FWIW, these halogen high hats have now been in
service for 10 years; it kind of sounds like one shouldn't expect them
to have lasted so long without earlier troubles. :-)

Thanks again,


-hh