Steven,

Here is a link to Eric's work turned out by his cheap home made tools. Click
on any picture and check out the dimensions of the vessels.
http://www.somegallery.net/lima/index.html

www.vintagetrailersforsale.com

cm


"Steven Raphael" wrote in message
...
My Idea of a cheap Bowl lathe.
Old Craftman monotube Lathe $10.00
Faceplates 4 inch disk $5.00 3 inch disk $0.00
above trued up drilled and tapped 3/4 16 tpi $0.00
Treadmill motor and controller $0.00

Total cost $15.00

I drilled and tappped the faceplates myself. trueing them up took a
litttle
while but they work.
I still have to make a freestanding toolrest but that may have to wait
until
it is a little warmer.