Thank you Gunner. This will be very helpful information.
RJ
--
"Have no one say it, and say it to your shame, that all was well here, until
YOU came."
"Gunner" wrote in message
news
On Fri, 11 Jun 2004 07:29:28 -0400, "Backlash"
wrote:
Gunner, how rough on the machine is rotary broaching on an Omniturn
GT-75,
using 5C collets, broaching an internal 6 point spline of around .312
overall diameter through brass previously drilled with a pilot hole of
the
proper minor diameter? How about a larger spline, around .437, through
12L14
Ledloy? The broaching would reach about 3/8" into the hole each part. I
would appreciate any comments you have on this.
RJ
Both should be just fine, if wobble broaching. The brass should be a
snap... the larger one may be approaching the limits. Be sure your holes
are deep enough for the broached material to migrate to.
http://www.omni-turn.com/Pages/Tooli.../broaches.html
The number for the Applications guy is
Randy Meyers
760-519-1276
Randy is VERY VERY good and can suggest some speeds and feeds, along
with the proper tooling. He is a sweetheart of a guy and sharp as hell.
Feel free to call me at 805-732-5308
Gunner,
"A vote for Kerry is a de facto vote for bin Laden."
Strider