Thread
:
production run gone wrong
View Single Post
#
20
Posted to rec.woodworking
charlieb
external usenet poster
Posts: 1,004
production run gone wrong
wrote:
I made myself a set of spacers to put between the (swapped) outer
blades from my dado set. voila! stock-thickness-independent tenons of
consistent size.
Nice - unless your stock thickness changes in which case you need
to adjust the fence
AND
it's not only the tenon size you have to worry about - but the
tenon's
location as well. Get apron legs off by just 1/16th inch on each end
AND in opposite directions then try and get a square table.
charlie b
if there's a way to screw it up
I'll find it - twice
Reply With Quote
charlieb
View Public Profile
Find all posts by charlieb