On Nov 15, 5:30 pm, Will Zenter wrote:
I'm trying to remove the DM module from a Mitsubishi DLP, model
WD52725, and I'm stuck.

I removed the back cover and the rear plate. I removed the four screws
that secure the electrical chassis, and I can move the chassis back a
few inches. I don't see how to remove the modules. Do I have to remove
the whole chassis? Does it come out from the back or through the
front?

If anyone has worked on one of these sets and knows how to remove the
DM module, please post the instructions. I would be very grateful.

remove the back, remove the rear plate. ther's a screw in the back
center of the chassis ,that screws to the bottom, gotta come out.
slide the whole thing out VERY carefully, and as you do, you will need
to unplug a connector or two. draw a picture so you don't screw up.
There are several wire(s) and bundles that must be loosened (untwist
the little white plastic nylon cable routing holder downers to get
enough slack top slide the chassis out VERY carefully until the module
can be removed.Again draw a picture, take a picture whatever so you
fon't forget where/how it all was before yiyou started. Fix it. the
4 caps are usually the prob. INSATLL the PC board FIRST, make sure
you line it up correctly and it should, with a little down pressure,
snap into place. don't make a mistake here. Then carefully slide
the metal box back over the whole thing ang put it all back together.

don't force anything.

go slow.

don't force anything

take your time.

don't force anything

make a picture.

save yourself $$. maybe up to $600 bucks.

Oh, and don't force anything.

Be gentle. It'll pay off in the long.


ixoye