How do I use a Split bolt ? (electrical)
On Mon, 12 Nov 2007 04:28:46 -0000, Albert wrote:
I have a 60 amp circuit with a single outlet (I believe an L5-50) that
I use for my welder. I want to add a second outlet to this circuit so
that I don't have to keep unplugging/plugging when I want to use
another welder. I won't be using both welders at the same time. The
conductors are 6 gauge. Normally I would use some wire nuts but I
can't find any that are rated to hold three 6 gauge conductors. The
home centers in my area have big blue wire nuts that can only hold two
6 gauge wires. They also have split bolts. Can I use these? Do I
just strip the middle of one wire and the end of the other wire, then
insert them into the split bolt? Then wrap with electrical tape? I'm
a bit leery of a 208V, 60A circuit insulated with electrical tape. Is
shrink tube any safer? Finding a shrink tube with diameter greater
than the length of the split bolt might be tricky. Are these split
bolts only intended for ground conductors?
I would add another circuit except my panel is completely full.
Any ideas? Thanks.
That will work fine. Id put in a sub panel with a breaker for each
welder..shrug..but thats just me.
Electrical tape is just fine. Wrap well with multiple layers.
Gunner
Political Correctness is a doctrine fostered by a delusional,
illogical liberal minority, and rabidly promoted by an
unscrupulous mainstream media, which holds forth the
proposition that it is entirely possible to pick up a turd by the clean end.
|