Pulley for treadmill motor question
Oops. Make that 0.672.
"Artemus" wrote in message
...
I don't own a lathe nor do I know anyone in the Portland OR area with
one. I did find a 43/64 drill bit at my hardware store which is 0.472 or
about 3 thou over. Is it feasible to use it and then use shim stock to take
up the difference? Or am I just begging for a wobbly pulley?
Art
"Karl Townsend" wrote in message
anews.com...
pulley with a 17MM bore? Alternatively would turning the shaft down
to 5/8 be feasible? Or maybe boring out a 5/8 pulley?
Do you owna lathe? Easy job to bore a pulley on the lathe. Don't even think
about working on the motor shaft.
Karl
|