Here's a web page with a nice chart for turning speeds. I keep it posted
next to my lathe for a good reminder to be safe.
http://turnedwood.com/LatheRPM.htm
Good luck in your turning.

Dan
"Joe" wrote in message
. net...
Is there are formula or rough correlation for a starting (roughing down)
speed as it relates to the diameter of the piece being turned? What do
you use? I have a Jet 1442 (reeves) and if it means i can't safely turn a
piece on its lowest speed, I'll have to make a design change.

I know there are many factors to consider here, including balance of the
piece being turned, I'm just looking to see if my lathe's low end is in
the neighborhood.


Thanks,

jc