Herb Robinson wrote:
I've been assembling pens for several years and recently have developed a
problem that I cannot figure out. When pressing the top portion of the pen
onto the bottom, if I go so far as to have the decorative ring of the top
part cover the screw mechanism of the bottom part, the mechanism binds and
will not turn. The decorative part on the bottom side of the top appears to
be centered properly, but binds nevertheless. I buy my pen parts from Craft
supplies the one I'm presently using is the Americana style, so assume they
should be good. My lathe -- a Jet mini -- appears to be centered properly,
but with the close tolerance we're talking about, it would be hard to see if
it were off a hair. As I said, looking at the finished product, the
decorative ring does seem to be centered. If I press the top only to where
it just touches the screw portion located on the bottom part it works OK,
just does not look good. Would appreciate any suggestions.



When I've had this problem it was because the end of one of the barrels
were not "perfectly" perpendicular to the pen tube. Using a pen mill to
true up the ends cured the problem.

--
Jack Novak
Buffalo, NY - USA