"Edwin Pawlowski" wrote in message
...

"** Frank **" wrote in message
Anyway, it still make ice cubes inside the freezer, but no ice dispensing
in chip or cube forms - no sound either from the motor or solenoid. The
ice water dispenser works but takes a long 10 seconds before the solenoid
kicks in. Before, we get instantaneous ice water when it was working
right. When I try to dispense ice cubes or chips I could see the
dispenser light cycle between normal and dim but no ice - must be drawing
current somewhere for the ice machine.

There are two components. the ice maker and the ice dispenser. Sounds
like the ice maker is good, but the ice dispenser is not working.

If the light dims, that means a load is being put on the motor. I'd say
either the motor is bad or the drive is stuck either mechanically (such as
bearings) or by the ice freezing it. First step is to empty the ice and
se if you can find a physical blockage in the chute leading to the auger.
If so, remove it or use a hair dryer to melt it.

You may find more information at www.repairclinic.com


Thanks Edwin. I wanted to learn more about ice makers and ran into this
video on YouTube on snap-in fitting. So cool, never seen this kind of
fitting for rigid copper tubings at the local hardware store.

http://www.youtube.com/watch?v=A9B5CgFAaqg



http://www.youtube.com/watch?v=A9B5CgFAaqg