On Oct 15, 2:09 pm, Ed Bennett wrote:
On Oct 15, 7:36 am, RayV wrote:
snip
Is it OK to have the dial indicator angled so the measurement can be
taken closer to the table or does it need to be 90deg?

The best practice is to keep the dial indicator plunger at 90 degrees
to the surface being measured (zero degrees tilt).

snip

Ed Bennett


http://www.ts-aligner.com
Home of the TS-Aligner

Looking at your site just made me realize that I don't need the
indicator near the table to check blade runout. I can do that up
high. I just need to get it close to 90deg near the table to check my
alignment.

Thanks again.