RayV wrote:
On Oct 15, 10:38 am, B A R R Y wrote:
RayV wrote:
Is 0.001" alignment close enough?
Is 0.003" blade runout too much?
How do test rips look?
Hard to tell, I went looking for a decent combination blade over the
weekend but couldn't find one. The Avanti (50T $30) blade cuts right
through Maple but leaves hatchet marks. I will stop at the Lumberyard
today and see what they have, I will probably end up ordering one of
these:
http://www.forrestsawbladesonline.co...worker_II.html
I love my WWII's, but a 24T rip blade is easier to use on thicker stock.
When I have more than a few rips to do, I take the time to install the
rip blade.
I've had Freud, CMT, and Ridge Carbide rip blades that I liked.