Hi,

I have an extension at the back.

When the then owners built it they moved the sliding patio door from the
original opening to the wall of the extension (sensible people) which left a
patio door size hole at the end of the lounge.

They partially filled this in with what sound like ply (about 9" each side)
and then erected a new door frame with a pair of very ugly doors. The doors
are about 32" - 33" each, with obscure glass.

I would like to replace these doors, open the space out again to the full
88" and have two pairs of folding doors.
Further, I would like the pairs of doors to swing out of sight i.e. round
the corner and back against the wall so that they don't take up any of the
opening, as they would if they just folded together up against each side of
the opening.

Problem is, I need two doors (glazed to let light through) of about 22" each
to do one side.
Also, I need the frames to be strong enough for the outer door to fully
support the inner door.

Has anyone done anything like this, and if so did they find the doors ready
made?

When I look for folding doors on t'Internet I find patio doors which are
expensive and a much higher spec. than internal doors.

I have seen some projects in B&Q (they were out of doors and the brochures
at the time) but these seemed to have asymetric pairs of doors.
I need the pairs to be symettrical as there is just room to fold a 22" door
behind the pillar, but no more.

TIA

Dave R
--