Le Thu, 11 Oct 2007 22:06:18 -0400, Phil Hobbs a écrit:

Gents,

As I was helping someone with a TIA design this afternoon, I had
occasion to read the data sheet for the OPA211, which appears pretty
similar to the LT1028, except that it's a bit more stable and doesn't
come in a plastic DIP. It has a curve of THD+noise vs rms output
voltage that I found very odd (see attachment).

Everything goes swimmingly until the signal swing on the inputs reaches
about 1V rms, and then it hits the wall. This is at a kilohertz, mind,
so it isn't an ordinary slew rate issue. It's also _way_ within the CM
range, because the plot specifies +- 15V supplies.

Since the problem surfaces at the same input voltage swing makes it look
like something in the input stage, but what in the world could be as
slow as that?

So what's up with this amp?


It seems they nicely screwed the DS there.

Not only the G=+1 curve is, ahem, a bit off, but it seems the G=+11 curve
could the G=+1 one: the G=11 curve shows 0.15ppm@3V, which is the stated
figure for the G=1 case.

They have a documentation feedback link in the page footer and I just
sent feedback. Let see what they say...

--
Thanks,
Fred.