Thread
:
Finished Long Parts Tumbler
View Single Post
#
16
Posted to rec.crafts.metalworking
Eric R Snow
external usenet poster
Posts: 24
Finished Long Parts Tumbler
On Tue, 09 Oct 2007 21:58:43 -0700,
wrote:
On Oct 9, 5:45 am, Randy wrote:
Viton is great for high temp, use Buna-N it's cheaper. Polyureathane
is the ideal choice for drive belt useage.
Speaking of which, I think I screwed up on my pulleys. The ratios are
right, but I'm having a hard time finding a belt. Both pulleys are 3L,
but the motor one is 1" outer diameter. Which is quite small for bore
size. I didn't realize how small until I saw it. I just assumed that
if it was a 3L pulley, that a 3L belt would work. But I'm not sure it
will bend enough around something that small. Can I just use a flat
belt or something?
Funny, it's always the projects you thought would be easy that end up
tricky.
Dave
There are available V belts that are notched on the inside so that
they are similar in appearance to a timing belt. These will bend
around a smaller diameter easier.
ERS
Reply With Quote
Eric R Snow
View Public Profile
Find all posts by Eric R Snow