Ignoramus3938 wrote:

On 2007-10-07, Pete C. wrote:
Ignoramus12852 wrote:

I am thinking about something. 480 VAC drives can be bought for next
to nothing. What they have is an inverter circuit and control
circuit.

They probably would not run on 240v because the internal transformer
that would supply voltage to the control circuit would supply only 1/2
voltage. They also might have an indervoltage sensor. I cannot think
of more things that depend on 480 volts being there.

So, if a hack could be done and a 1:2 transformer inserted between
480v inputs and the control circuit, then the drive would become a
240v drive with the same amp rating (and half HP).

What am I missing?

i

It might be an interesting experiment, but since new drives up to a
couple HP are in the $200-300 range and have a warrantee it would seem
to not be worthwhile if you put some reasonable value on your time to
make the modifications and on having a drive with a warrantee operating
within it's design parameters.

I am thinking more about 40+HP drives. But the experiment has value. I
placed a few snipes on 480v VFDs and will report my findings.

Trying to run a 40 HP VFD on your 200A residential 240V service is sure
to let magic smoke out somewhere, not to mention ****ing off the wife
when the house power drops.


If you have enough machines that could use VFDs, you're likely better
off strapping their motors for 480V, buying the super cheap used 480V
VFDs, and finding a single good sized transformer to setup up the shop
240V to 480V to feed the drives.

That's definitely another practical possibility.

i