Adjust depth on Porter Cable finish nailer?
On Fri, 5 Oct 2007 16:22:29 -0500, "DK" wrote:
I borrowed a friend's Porter Cable 2-1/2 inch, 15ga. finish nailer to
install a window. It doesn't sink the nails far enough, even when I have the
max air pressure set.
My friend says you can't do anything about that, but don't Porter Cable
nailers usually have a depth adjustment? If so, where would it be and what
does it look like? I haven't used one of these before, so any help would be
appreciated.
Check for a small dial under the trigger or there about. Turn the dial
to adjust. Test on scrap material.
If it doesn't have a depth adjustment, what else can I try? Could it not be
sinking them because it hasn't been oiled in a while? Anything else I should
check?
Thanks!
--
Oren
"I didn’t say it was your fault, I said I was blaming you."
|