Vise for pipe threading
Ignoramus11107 wrote in
:
I had a chance to thread some 1/2 NPT pipes. The threader worked,
however, the vise (Harbor Freight 4" vise) could not hold the pipe
well, so the pipe would slip. I tightened the vise rather well. This
is a vise with no special pipe holding provisions.
My question is, is the vise somenow not as good as it should be, or
was it simply a wrong tool for the job? Do vises with pipe "slots"
hold round objects better?
i
Flat jaws are not for pipe. You would have had much better luck if you had
clamped a set of v-blocks in the vice to hold the pipe.
Real pipe vices use a chain and serrated V's. (Rigid Industrial).
--
Anthony
You can't 'idiot proof' anything....every time you try, they just make
better idiots.
Remove sp to reply via email
|