My experience is yes, the pipe jaws do hold pipe better, after all, that's
why they are there.
Threading 1/2" pipe being held by the flat jaws of a 4" HF vise is asking a
lot. My $0.02
42

"Ignoramus11107" wrote in message
...
I had a chance to thread some 1/2 NPT pipes. The threader worked,
however, the vise (Harbor Freight 4" vise) could not hold the pipe
well, so the pipe would slip. I tightened the vise rather well. This
is a vise with no special pipe holding provisions.

My question is, is the vise somenow not as good as it should be, or
was it simply a wrong tool for the job? Do vises with pipe "slots"
hold round objects better?

i



--
Posted via a free Usenet account from http://www.teranews.com