Fans in Series
would it be easier to just run a neutral wire back to the panel and use one
of the existing hot leads, and run your fan on 110?
"Paul" wrote in message
. ..
There's metal content as this will be part of a lathe repower project.
If one were to take two fans, something like square framed heat sink
fans,and stack them one after the other would they act as a 'two stage'
fan, so to speak?
I'm changing my lathe over to a VFD and as the motor will be running at
slower speeds I think extra cooling will be required. There's no 120 VAC
on the machine but I can easily get 220 VAC. Yes, I could buy or scrounge
a 220 volt heat sink fan but I'm thinking about wiring two 120 volt fans
in series as those are much more common and as long as I was going to have
two I started thinking if stacking them would offer any advantages.
regards
Paul
--
-----------------------------------------
It's a Linux world....well, it oughta be.
-----------------------------------------
|