"Kevin" wrote in message
...
Hi,
I have a swimming pool type pump, actually from a hot tub - no
inbuilt
filter but you get the idea.
The motor has gone partial short circuit so I need to get the motor
rewound.
My issue is I can not see any obvious way to remove the plastic
based pump
casing from the motor housing.

In the good old days a motor had a shaft with a key and it just slid
on and
off.
This may be the case with this set up but there is no place to put a
puller
or any shaft lock nut that I can see.

Has anyone come across this before and can shed any light?

The Motor is an ITT Marlow Type 80/2 ITT No. 00456
The pump is marked Hydro air ITT Industries J250SC

Any enlightenment received with thanks

...I've googled without any luck.

TIA

Kevin


You may well find it best to supply your rewinder with the assembly as
he will have the appropriate equipment to hand, and can get it all
back togther after rewinding.

AWEM