"Matt" wrote in message
ps.com...
Going to build a rolling cabinet for my planar (approximately 2' x
3'). I was thinking about whether or not I need a vertical member
centered in the middle of the cabinet to support the weight of the
machine. Any suggestions? I dont see a way around it. If I do add this
support, I was thinking about adding several drawers to the top
section, and two cabinet doors to the lower half. Any of you have an
outfeed table? What are you fellas storing is this cabinet?

Matt

This is the plan I built. I like it very much. I have never had a problem
with snipe. I have a Delta planer.
http://woodstore.net/porplanthicc.html