Rolling cabinet for my planar
Going to build a rolling cabinet for my planar (approximately 2' x
3'). I was thinking about whether or not I need a vertical member
centered in the middle of the cabinet to support the weight of the
machine. Any suggestions? I dont see a way around it. If I do add this
support, I was thinking about adding several drawers to the top
section, and two cabinet doors to the lower half. Any of you have an
outfeed table? What are you fellas storing is this cabinet?
Matt
Offhand, I'd say it depends on exactly what the top if to be made of and how
thick it'll be.
If you are planning to use 1/2" plywood or MDF, I'd run a support rail under
it; however, if it'll be something more substantial...say 3/4" baltic birch
or a lamination or maybe even a torsion box, no extra support is likely to
be needed.
Luck
Mike
|