Ok. What do you recommend as my next step? Should I try and measure the
voltages on all 14 pins and post the results?




Arfa Daily wrote:
Arfa:

[quoted text clipped - 17 lines]
seeing
an email address.

OK. Well that basically tells us that the problem is not the protector, or
probably its feed either, so it will be necessary to start checking the
output voltages of IC502, which is where it gets complicated, because as it
only stays on a second or two, before dropping back to standby, you don't
have long to evaluate what is appearing on the chip's outputs. As it is also
possible that the input voltages never have time to reach their normal
running level, it takes a degree of experience to determine if output pins
that are reading low in that second or two, are *heading* for the right
level ...

For an e-mail direct to me, use

Arfa

--
Message posted via ElectronicsKB.com
http://www.electronicskb.com/Uwe/For...epair/200708/1