View Single Post
  #15   Report Post  
Posted to alt.binaries.schematics.electronic
John Fields John Fields is offline
external usenet poster
 
Posts: 2,022
Default 3.6VDC voltage sag on switching

On Thu, 14 Jun 2007 15:06:52 -0600, "starfire"
wrote:


"starfire" wrote in message
...
I'm posting the associated circuit and traces here, per request from Paul
Hovnarian. Thanks for the suggestion, Paul.


I'm posting some traces from some of the implemented suggested
modifications:

trace 1: no load from switched 3.6VDC to ground
trace 2: 1K-ohm load from switched 3.6VDC to ground
trace 3: 100-ohm load from switched 3.6VDC to ground
trace 5: 10-ohm load from switched 3.6VDC to ground

I installed 10uF caps across the exisitng input 1uF caps on the input and
output of the TC1108 voltage regulator.
I also installed a 10uF cap across the existing 0.1uF cap on the Vcc and
ground leads of the PIC right at the power pins.
I also removed C30 (the 0.1uF cap on the drain of the N-Channel MOSFET and
the gate of the P-Channel MOSFET.

As can be seen in the traces, the dip seems to be unrelated to the amount of
switched current. The dip is also reduced significantly in amplitude now.
The switching action works now every time I tried it. This was all very
welcome news!

I used 10uF caps because that's what I had on hand and they were small
enough to fit nicely across the pins of the voltage regulator. I will try
to find some 22uF (or so) caps to see if I can reduce the dip even further.
This is very hopeful...

I tried the series diode with a BFC from the PIC Vcc to ground on a separate
breadboard to convince myself this will work, also. It looks like this
approach would work, too. I'm a little reluctant in going that way if I
need to get analog inputs from an accelerometer (which is a proposed add-on
to this system). If I use a Schottky diode drop from the raw battery to the
PIC (along with a BFC to ground), the PIC Vcc could vary significantly
dependant on the current load going into the PIC and the charge status of
the battery. I will keep this one in the back pocket, though...


---
Since the ADC in the PIC is ratiometric, (I believe) there will be
no errors due to changes in Vcc if you excite the accelerometer with
Vcc.


--
JF