Keith Dunbar wrote:

You must forgive my ignorance of the names of all the funny bits of roofs
....
(maximise screen to view this best)

THese pictures only really work if you use a non proportional (e.g.
courier) font to draw them and view them....


|
| | | |
| | | |
| | | |
| | |
|
| | |
|
| oooooooooo | | ooooooooo |
| | | |
| |
| | | |
| |
| | | |
| |


There is just about room for a 4' width of chipboard at "ooooooooo"

Where would I be best (i.e. cheapest) going to for this PIR board?

A specialist insulation provider probably. One of the outfits that can
supply "seconds" would be good for this application.

How strong is it?

Fairly stiff - stronger that expanded polystyrene for example.

Can one stand on it?

If it is laid flat on the floor then yes. If you are laying it across
joists then I would not stand over the centre of the span unless it had
a board over the top.

I would need lots of quite long screws to fix the
flooring to the joists.

Probably.

Is there any reason why I should need to. Could I create a sort of raft of
flooring above the PIR?

If you have a reasonable area of it, and the covering will remain in one
lump without fixing then a raft would work.


--
Cheers,

John.

/================================================== ===============\
| Internode Ltd - http://www.internode.co.uk |
|-----------------------------------------------------------------|
| John Rumm - john(at)internode(dot)co(dot)uk |
\================================================= ================/