"surftom" wrote in message
om...
Hi Gang -

In the process of finishing the hydraulic punch and have a question on
tooling.
I have to build a railing (steel) and want to use 1/2" SQUARE bar for
the stiles (vertical) that pass through a rail (horizontal) 2" wide x
1/4" thick flat stock


My question would be why bother to pinch any holes? Just make a jig to
position your vertical posts and weld away.

For the legs, just weld on in line with the upper posts.

--

Roger Shoaf

About the time I had mastered getting the toothpaste back in the tube, then
they come up with this striped stuff.



Should I punch with a 1/2" square punch or go up to the 9/16" punch.
The intent is to weld around the bar when in position. Does a 1/2"
punch actually make a 1/2" hole or is it a little bigger? Also, what
are the tolerences on typical steel bars (when they say 1/2" is it
really 1/2")?
Always drilled and never used a punch before so am a little unsure.

Thanks in advance...

Tom

PS... What else can I do with a hyraulic punch? :-)