"Joe" wrote in message

Common practice is to install new meter base, weatherhead and run new
wiring to the breaker panel.

This is being done.

than to install a junction box and splice in more wire.

But how do you transfer all the existing 10-14 ga wires from the existing
fuse box, to the new panel. Even if located in exact same spot, the
geometry is different and many of these will not be long enough. Is there a
clever way to "extend" them :-) That is why I asked if a box with terminal
strip can be used for this purpose. Such box could be physically located
above present fuse box, to make sure existing cables would be long enough.

RichK