If you're having just too much trouble painting with a small brush after
you route, you can mask the area, route through the masking, then spray
paint. If you want as much coverage as possible in a single application,
you can try the following:
- painting on a thin layer of rubber cement - this will stick, but can be
easily peeled up after painting (or use liquid frisket, see below)
- using sheet frisket, a masking material used in airbrushing, available at
hobby stores or on-line (or use rubber cement to glue on a sheet of acetate
film)
- using sheets of self-adhesive label material. Avery makes 8x10 sheets of
the stuff

Milt wrote in
om:

...snipppppp........

Does anyone know the best method for this?

Someone suggested covering the face of the board with "blue tape" like
for painting - then routhing thru the tape,. spraying after the
routing, then removing the tape. I have not tried this yet.

Any ideas would be appreciated.

THANKS!
Milt