Phisherman wrote: The lower 12" or so of the raising rack
Pete Stanaitis ake it to a welding shop and have it brazed

Welding shop worth its weight should need neither jig nor your
services to file the teeth after the brazing!



n Jul 24, 11:13 am, spaco wrote:
The rack may well be cast iron. Take it to a welding shop and have it
brazed. Maybe make some sort of fixture to hold the parts in place to
make it easier to get a good match up. On a floor drill press, I
don't see that you'd be actually using that part of the rack much
anyway, so a poor fit up might not be a show stopper anyway.
Let the weld shop do the brazing and then you file out the
tooth/teeth where the brazing took place.

Pete Stanaitis
------------------------------

Phisherman wrote: The lower 12" or so of the raising rack
Pete Stanaitis ake it to a welding shop and have it brazed

The lower 12" or so of the raising rack on my Delta 16-1/2" floor
drill press broke off. Anyone know how to repair this? Or, is
there any online vendors that sell replacement parts? Any
alternatives? Thanks

Phisherman wrote: The lower 12" or so of the raising rack
Pete Stanaitis ake it to a welding shop and have it brazed