Machining 0.250 inch square hole?
On Jul 19, 2:29 pm, Nick Mueller wrote:
John Martin wrote:
I've often thought about making up a toolholder for my shaper that
would allow mounting a bit in line with the ram movement axis. You
could use, say, a 3/16" square bit and feed it into the corners.
Something like this:
http://www.motor-manufaktur.de/werkstatt/10_keyways/en_index.html
And yes, you could quite easily get the 0.05mm tolerance.
Nick
Nice job. I thought of making a holder to replace the lantern
toolpost and take a HSS tool bit at 90 degrees, and not worry about
any relief. For longer cuts, though, I can see that having the 5
degrees clearance makes a lot of sense.
John Martin
|