Arthur2 wrote:

I think this thread got distracted by the 'shooter' discussion.
Whats wrong with a flush/trim cutter with the router?

I think I am getting lost as well now ;-O

Which flush / trim cutter did you have in mind, and what were you
planning to do with it?

(you linked to a T&G cutter set before)

Flush trim cutters:

http://cgi.ebay.co.uk/FLUSH-TRIM-KIT...QQcmdZViewItem

are fine if you want to trim an overhanging top layer of something back
to be flush with a base layer. Quite handy when glueing veneer over a
base board.

One with a bearing diameter greater than the diameter of the cutter.

How much greater?

Piece of 6mm mdf gripping the wood from below via 2 half inch nails.

What wood?

If you mean how to join square edged planks into a stair tread, then
glue and biscuits will work well.

Must be easy.

Probably is, but I think some detail is escaping my grasp at the moment.

--
Cheers,

John.

/================================================== ===============\
| Internode Ltd - http://www.internode.co.uk |
|-----------------------------------------------------------------|
| John Rumm - john(at)internode(dot)co(dot)uk |
\================================================= ================/