Arthur 51 wrote:
Hi all.
Finding 10" by 1" oak or beech is not very easy. So having ordered a
1/2" router
I can now consider T & G two 5" wide peices.(without bevelled join)
If I do some research on this will it be doable by a first timer or
expensive firewood?
Thanks.
Arthur
Arthur,
You would be better off 'shooting' the boards with a 'jointing' plane and
using the 'rubbed' glue joint method as opposed to t&g for finished
joinery - there are various methods for doing this by the way.
A couple of reasons why:
1 - If you use t&g you won't have enough area for the glue to hold properly.
2 - That area will have 'hollows' in the surface from the machining
process - which will again reduce the glue area to the tops of these
'hollows'
3 - The above may well lead to shrinkage after gluing - and certainly will
if the joint isn't glued.
As a matter of interest, if you are having difficulty in sourcing your
materials, have you tried a local sawmill - see the link for a list -
http://www.touchlocal.com/nat/c-1713-Sawmills?
If there is one near to you, you should have no trouble getting them to cut
your material to size - especially oak or beech.
Brian G - not a stair expert by the way, just an old chippie.