On Sat, 07 Jul 2007 08:35:38 -0400, Meat Plow
wrote:

Locate someone who repairs them and get a replacement. Why did you pull
the jug off if the bolts were just loose? Doesn't make sense.


To clean up the oi/gas mess in the recesses. Lawn work would soon
build up a thick crud otherwise. Also to remove the thick red-ish
deposit of sandpaper like oxide on the cylinder head. Did that with a
Dremel wire brush attachment. Lesson here is not to work on
unfamilair reassembly when the light is bad and I am tired. That was
an easily avoidable mistake.