I will give that a try, thanks.

"Leonard Caillouet" wrote in message
...
Have you tried resoldering the bad joints in the IF block? Very common on
these uints.

Leonard

"Chris F." wrote in message
...
This may be a toughie.... the set will tune in a station but will not
lock on, it just drifts back and forth, alternating between a picture and
snow. I replaced all the caps in the tuner section and it made no
difference. I can't locate a pre-scaler IC (which I've seen go bad on
other sets), so I'm assuming it's built into the tuner itself. Am I
looking at a bad tuner at this point? (Part# 1-463-771-11)
I'd normally junk anything needing a tuner, but this set just has too
nice a picture to give up on it.
Thanks for any advice.

--
To reply via Email, remove NOSPAM from the address