On Tue, 03 Jul 2007 00:37:01 -0700, yshaikh01
mused:

Hi
I have purchased a Monobloc Basin Tap. I wanted to fit this into a two
hole basin. The diameter of the holes in the two hole basin are approx
34mm. I tried to fit the tap but it does not fit by about a couple of
mm (approx 2-3mm).
I was wondering if there is anything I could do to make it fit as its
only a couple of mm out.

Step drill\cone cutter, such as
http://www.gjhall.co.uk/eng/multicut.html.
--
Regards,
Stuart.