On Jun 22, 7:09 am, normanwisdom wrote:
On 21 Jun, 21:07, "Brian G" wrote:
I personally wouldn't even consider using a router for hinges unless it was
in the workshop and then only on a fairly long production run of door and
frame sets.
Absolutely agree with that. Taken the words out of my mouth!
Whoa! What did the OP ask again?
I just said for a couple of hinges it's do-able without a jig *if* a
bit of care is taken.
I've seen a few dodgy chiselled hinge rebates done by tradesmen.
And I haven't seen many where the hinge screw slots line up perfectly,
LOL
cheers,
Pete.