PS transf. to heat sink glue?
On Sun, 27 May 2007 18:41:33 +0100, Gibbo wrote:
John Larkin wrote:
Besides, filled adhesives aren't all that much better than unfilled
ones, even if the filler is diamond.
I made some measurements on Araldite filled with copper filings to quite
a high density, basically as much copper as I could get in there and
keep it workable. The heat transfer through it was amazing. I was quite
impressed.
Then my techie did the same tests with plain Araldite and the results
were a few percent worse. It actually made hardly any difference. So
you're bang on.
I would say that those "tests" were flawed then, as were the results,
and likely, the methods.
|