"John Grabowski" wrote in message
...

"Eigenvector" wrote in message
. ..

"John Grabowski" wrote in message
...

"Eigenvector" wrote in message
. ..
Has anyone come up with a better way to mount a bathroom fan so as to
minimize the vibration they produce? Seems like the traditional 2
screw
mount of the normal NuTone bathroom fans would absolutely magnify any
sounds
and vibrations produced by the unit.

Would it help to put a stringer on either side of the fan so that
vibrations
are transmitted to the framing?

I don't want to turn this into a physics exercise so much as learn
about
better methods used.


The better quality fans such as the Nutone QT series or my favorite,
Panasonic, don't have a noise problem. Look at the sone rating for
each
fan. Less sones is better. I think a Panasonic 80 CFM fan is .4 sones
whereas the cheap fans that builders usually install are 6 or 7 sones.


Sure I know there are better units available, but that's not really what
I'm
asking.

What about quieting down the one that already exists?


You could try using some rubber mounts or put a rubber block between the
fan
and joist, but I doubt that will do anything significant. The small
cheapo
fans operate at higher RPMs than the larger more expensive quiet fans.

Save your efforts for some other project. If you want a quiet fan, then
buy
a quiet fan. When you go to sell the house potential buyers will notice
the
difference as their current dwelling will most likely have a noisy fan.


Well if I had a 100 bucks for a decent fan I'd spend the money on paying
down my debt and stick with the noisy sucker I have. I have a feeling
you're ultimately correct but that don't mean I won't try.