In article ,
John Rumm wrote:
Comments here on on the wiki discussion page as you prefer.

One comment only - you say to use a purpose made heat gun to shrink the
heat shrink sleeving. These are very expensive and an ordinary hot air
paint stripping type can safely be used - just don't hold it stationary
too close for a long period. A dual heat type on low is the ideal. Hold
about 3 inches from the work and move from end to end until it shrinks.

--
*Parenthetical remarks (however relevant) are (usually) unnecessary *

Dave Plowman London SW
To e-mail, change noise into sound.