DIYbanter - View Single Post

Peter Huebner

In article ,
says...

Because of the depth of the cabinet, the disk cases will stand on edge in
rows running front to back. Everything is fine and dandy when the drawer is
filled to capacity, but I'm looking for ways to keep a partial row of disks
from toppling over as the drawer is opened and closed.

Would appreciate any ideas you can share.

An l-shaped strip of stainless (say 2"x6", bent around 2/3 of the way down)
will do this in and attractive and simple way.
Slide the longer end under the cd cases and the short upstanding end will act
as a stop. Good idea to round over the corners...

Since I've been too lazy to drive 140 miles to organise a few of those so far,
I just use a few blank CDs in 'crystal cases' as backstop, lying on the flat
;-)

-P.

--
=========================================
firstname dot lastname at gmail fullstop com