On May 5, 11:48 pm, "Roger" wrote:
I have an overhead aluminum screen enclosure two sides of it are attached
to
the house's fascia board. The fascia boards are in pretty bad shape some
parts are so rotten I can make a dimple by pressing my finger into it. It
is a recently purchased house so it's been in neglect for years. The
leaves from the tree traps in the "valley" between the bottom of the tiled
roof and the bottom of the screen enclosure, and sat there, trapped
moisture and caused wood rot. I removed a small section of the eave and
peeked inside and I can see the fascia boards are attached to some 2x4
laid 24" aparts, each 2x4 is attached to the roof framing at an angle
(hard to explain) and some of the 2x4 are also rotted a bit where it meets
the rotted fascia boards. So the work I would need to do a (1) Detach
and dissemble the screen enclosure at least on two sides where it attaches
to the structure.
(2) Remove all fascia boards and replace with new PT wood fascia boards.
(3) Examine the 2x4 where the fascia boards are attached to, and it any
rots occurs - I am not sure what to do, either replace or install a sister
2x4 next to it.
(4) Replace the sections of eave that are also rotted.
(5) Prime and paint all new wood.
(6) Reattach the screen enclosure again.
(7) Install a "lid" over the "valley" to stop rain and leave from
collecting there. I want to hire someone to do this. I just don't know
if this is a roofer's job, a screen enclosure guy's job or a carpenter's
job. I called around and no one wants to do it all, they all just want to
do the screen part, or the framing part etc...I have trouble finding a
"general" contractor to do repair oriented work.

First take all apart that is possible, without major leaking.
Then assess work to be done.
Roofers do lousy carpentry, so the first shot is a good carpenter, with
local references.
The enclosure may have structural and drainage/design problems, so you need
advice on whether attachment to house is the problem, not just leaves. If
the enclosure were properly attached, water would still drain off, if enough
pitch was used, even with debris around.
Once roof/enclosure connection is proven sound and properly pitched, get the
carpentry repairs, cover with temp. tarp, and get several roofing estimates
for reroofing.
Roger

in buffalo ny we have used this company for roofing with carpentry
repairs:
http://www.trylock.com/