How about a router and a trim bit with a bearing on the bottom riding
against the riser. You can finish off
where they extend into the wall with a saw of SHARP chisel.

Ted
"JGS" wrote in message
...
Hi,

I am laying a laminate floor for a friend. I need to do about 6 steps too.
In order to install the material on the steps, I need to remove the tread
nosing flush with the riser.

The nosing is about 1.5"thick by 1.5" deep. Any ideas?

The treads extent into the walls therefore I cannot just remove the tread
to do the job.

Thanks, JG