On Tue, 24 Apr 2007 22:08:18 -0400, Allan Matthews
wrote:

Building up a 4X4X30" block of hard maple using 3/4" thick boards.
Never used Gorilla glue before but bought some today and glued on a
board and heavily clamped it, but did not moisten the board as per
directions. (didn't read directions). How much of a problem will this
be? A horribly weak joint or a very strong joint but not as good as
it might be if done correctly?Any comments appreciated.
Allan

Block is to be sawn lengthwise on an angle to make two pegboards for a
hammered dulcimer. Glue that was squeezed out was foaming and so I
believe it was activated but am not that familiar with GG..My choices
are to use it or saw it apart and start over.