In article MPG.19d4cdcd7efc61b9989c90@localhost, Colin Blackburn
writes
On the general theme of aerial installations is there a reasonable way
to wire in several aerial points off one aerial without a distribution
amplifier, ie just using a splitter or splitters. Say I want four
sockets, should I split near the aerial or run a single co-ax as far as
possible before splitting? There would only ever be one socket in use at
once but I can appreciate that long 'stubs' may cause various problems
on the line as a whole.

Colin

Yes what you state with long stubs will be problematical. Use a
distribution amp a good one can be had for about 20 quid and then look
forward to many years of use with good clean signals. A splitter will
work but it divides the available signal....
--
Tony Sayer