View Single Post
  #1   Report Post  
Posted to sci.electronics.repair
Barry & Nikki Barry & Nikki is offline
external usenet poster
 
Posts: 23
Default Anyone NEED these test jigs?

I have the following items. Please bare with me being I have found very
limited info. on these. I am assuming that if you are looking at this post
then you are familiar with test jigs. Anyhow I have the following:

Sharp Jig- QPWBF2382TAZZ w/ QPWBN2381TAZZ attached to it. I could not
find anything out about this item. It has 8 slide switches and one push
button switch. From Left--Right Top--bottom they are labeled as follows:
Sensor, Error Display, Manual SW-P Adj, (push button) Auto SW-P Adj.,
(bottom) VCR Adj, Low Bat, A-Track, Adj Mode, RE Test. There are also
various test pin clips on the right hand side which are labeled: H-Amp-SW,
H-SW-P, 16.5V, EE Lev, W/D, PB FM

Sharp Jig- QPWBF2450TAZZ including QCNW-1275TAZZ (VTR Adj. Jig cable)
The first one mentioned has 8 switches and one push button (stop Adj.)
labeled as follows: 1.) CAM/VTR Power switch 2.)Sensar Adj. 3.)Mechanism
Adj. 4.)Battery Adj. 5.)Error Indication 6.)Pass Mode 7.) CAH Adj. 8.)VTR
Adj. Then there are 14 test pins labeled TP1-14

Hitachi DSP R Interface Board Jig MCM part #7099448 w/ DSP AV output
adapter MCM part #7099456. This jig also has three spring clip test probes
(black, yellow, white). Has a 9-pin female serial type connector as well as
a 25-pin connector.

Sharp "Fixture" jig: w/ extension cable. RUNTK0309TAZZ . Not much to
explain other than a bunch of surface mount electronics including a remote
control sensor diode and three female RCA Plugs labeled: Video Out, Monitor
Out, & Video In.

Samsung interface board Ver. 2.0: Small silver rectangle box (4 1/2" X 2
1/2" X 1 1/4") One end has a 25 pin female parallel plug. The other end has
a DC 6V plug, a plastic 3 pin plug in that is labeled "ADJ", and a 15 pin
female plug labeled "DDC"

LG Monitor Adjustment adapter: (5" X 4 1/4" X 1 3/4") One end has two toggle
switches; one labeled in the upward position "V-SYNC" the other "ST". Next
to that is the red LED power indicator and then the wall plug in. The other
end has a 2 male pin plug in labeled "RS232C" and next to that a 25 pin
female parallel plug in. On one side there are two 15 pin female plugs. One
labeled "VGS" and the other "MONITOR".

OK now that that is over with and if you are still baring with me; if
you need pics. I can email them to you so that you can see exactly what I am
describing. Just inquire about a specific item and I will get to it ASAP.
So
feel free to email me (must remove appropriate items from address to send)
if any or all of these items interest you. Thanks and take care.