Jet 1442 Problem
The GFI will rip easily. The extension cord could also make it trip if not a
large guage... at least 12 and no longer than 25feet.
"Joe" wrote in message
...
I have the above woodturning lathe and it's been acting strangely all of a
sudden. The complete sequence of events.
- Lathe runs fine in the garage/shop, although not much time put on it.
(bought it new)
- All of a sudden, every time I try to turn it on, it trips the GFI it's
plugged into
- I use an extension cord to plug it into a non-gfi, and it works fine,
for a (very) little while
- Now, when i turn it on, (it's a capacitor start/capacitor run motor), it
doesn't kick over from the start capacitor to the run capacitor which is
usually accompanied by a definite "click" and a smoother run after it
kicks over.
questions:
Is this what happens when a capacitor (the start) goes bad? Or is there
something in the kickover that can/has gone bad?
The motor has very little run time, this seems very odd to have happened
already.
would the bad/going bad capacitor cause the gfi to trip every time?
Any help would be appreciated.
Joe
|