carneyke wrote:
On Mar 4, 10:37 pm, David Brodbeck wrote:
I have an ASK Impression 880 LCD projector. I need to know how to reset
the lamp life warning. I assume it's in the service menu, but I don't
know the code to get in. I already replaced the lamp and ballast,
because the old ballast blew quite spectacularly a few months ago.

IIRC : There is a switch on the motherboard. Turn unit off (unplug),
open cover and set switch (only one on mother board) to opposite
position that it is in. Put cover back on, plug in and go. Thats
all................


Well, I took it apart, but I couldn't find a switch anywhere. I could
have sworn I remembered there being one, but I also used to have a very
similar, but slightly older, ASK projector and it could be that I'm
remembering it, instead.

Under the OPTIONS menu, there's a SERVICE option that I suspect is the
answer, but when I select it I get a little box that says "SERVICECODE?"
and I'm not sure how to proceed from there.

I need to figure this out because, without a reset, after another 50
hours the projector will shut itself down and become a very large
paperweight.